ATEN Global Service Site


Subject :
	CS1762 DVI-A Support?

Description :
	I have a Samsung monitor with DVI Input, a PC with DVI Output and a notebook with a VGA Output. The PC runs very well, but with the notebook, I get no signal on the monitor. I use a normal VGA cable with a VGA-To-DVI adapter from my notebook to the KVM Switch. What can I do to get my notebook running ?

Solution :
	If your monitor only supports DVI-D signal, please try to find a converter to convert the VGA signal to be the DVI-D signal for your notebook. Then, the monitor will display for your notebook. However, almost all the DVI monitors support DVI-D and DVI-A signal, so please check the spec. of your monitor again. If your monitor supports both DVI-D and DVI-I signals, you just need a DVI <-> VGA adapter (or cable as same as your description) which could be found at some electronic shops.

Related FAQ :
	Firmware upgrade from a PC without COM port
	cascade menus
	CS62A's Hot Key
	Hot Key
	Invoke HSM without NUM-key


Was this information helpful?		Y N
Any Comment?

Thank you for your valueable comment!!!!

Still need more assistance?