ATEN Global Service Site


Subject :
	VS0801H and VS0801HB switching behavior

Description :
	Could you please advise how does auto-switch work on VS0801H & VS0801HB when HDMI cable is plugged out? It is clear when HDMI cable is plugged in, it switches to this port. But how about when cable is plugged out?

Solution :
	Actually there are 2 settings in VS0801HB, one is the behavior that when new source is connected, one is when the source device is power off(+5V doesn't have power). 1. The command swmode off, swmode next, and swmode priority are the behavior when new source is connected(HDMI cable is plugged). 2. The swmode pod on and swmode pod off are the behavior when the source device is power off. When pod is on, VS0801HB will switch to the port which is power on(connected and +5V is detected) when you unplug the current used HDMI port. These 2 modes could use together. About VS0801H, it's the same behavior. The goto command in VS0801H is the same behavior as POD command in VS0801HB. The swmode auto command in VS0801H is the same behavior as swmode priority command in VS0801HB.

Related FAQ :
	如何設定IP 位址?
	How do I assign an IP address?
	手动将CN9600本地端monitor的EDID写入CN9600
	我要怎麼做才可以重設VM51616H密碼呢?
	한쪽 PC 시스템 종료 후 Port 전환 안됨


Was this information helpful?		Y N
Any commend for this FAQ?

Thank you for your valueable comment!!!!

If you need more assistance, please click the button on the right (Ask Question) and one of our experts will help you