The signal loss is because the network cable is affected by radio waves. It is recommended to use better shielding network cable like ATEN 2L-2910 and use Electrically Conductive Adhesive Transfer Tape(ECATT) to bind the RJ-45 connector to isolate the interference from other devices like Walkie-talkies. Please refer below:
- Prepare about 15cm of Electrically Conductive Adhesive Transfer Tape(ECATT).
- Cut about 1cm of the cover of the network cable
- Make sure the inner side of aluminum foil is conducted.
- Make the aluminum foil clad inside out to the appearance of the network cable.
- Use the Electrically Conductive Adhesive Transfer Tape(ECATT) to bind at the connector.
- Finish
|